Install explanation about IR filter
The particular install approach·classify introduction:
A．The installation mode s of chott-glass IR-CUT /DAY AND NIGHT FILTER：
First, you need to lay UV glue on the surface of sensor glass equality, or use the filter glue paper keep close to the four sides of sensor.
Then keep the filter cling to the surface of sensor.
If you stickup the filter by UV glue, after it you must have a irradiation by ultraviolet radiation lamp to make it solidify at short notice
B. The install approach of OLPF filter (single or double layers):
First, you need to assort the positive and negative layer by identify Phnom-Penh. The layer contain Phnom-Penh is positive layer, then the other layer is negative layer.
Keep the positive layer upwards, and then cling the negative layer to the imaging glass surface of CCD or CMOS.
Afterwards, you have to daub the UV or AB glue on it, and have a irradiation by ultraviolet radiation lamp to make it solidify after extrusion air completely .
C．Install approach of intervene filter:
Keep intervene filter let in the top of photosensitive resistance ,and insure it had been fix steady.
Then cling intervene filter to the sensitization area of photosensitive resistance directly by the UV glue.
In the end, you must have a irradiation by ultraviolet radiation lamp to make it solidify at short notice.
Use direction
First, When you want to open up package to use the product, you must insure the circumstance clean enough or at the purify plant.
Second, If the surface does not clean enough, you can blow the surface to clean by puff balloon equipment.
Third, you have to wear the fingertip during fixing process, and your finger can’t touch on the surface directly.
Fourth, rigidity low(5-6), easy to scratch, please not touch the surface by any rigidity content.
Deposited propose
① Normal temperature , Air conditioning room .（temperature：20℃，humidity：50％）
② Optics dry case, moor temperature and humidity.
③ Vacuum case.
